the headstamp is marked 7.62x39 with a 76 at the top. Primers have the green coating. I don't believe it to be Portugese and not sure if it is corrosive or not. Anybody familiar with this type of ammo? I bought it from AIM a while back. Thanks.
| About this site |
|---|
| C&R Dealer Links | General Related Links |
| The Member's Map | The Gun Control Forum |
Due to the main focus of this site on the collecting and shooting
of C&R and military surplus firearms in their collectible original configurations,
sporterizing topics (ex. "how-to sporterize", or "hey, check out my cool sporter") will not be permitted in these fourms.
Thankyou,
ParallaxBill
Parallax's Trader Boards
See the new location at the bottom of the forum list
**Membership applications no longer required to post but you still must be registered.**
No dealers please!
Back in Production, New and Improved
Darrell's Scout Mount Page & Forum
| Author | Comment | ||
|---|---|---|---|
VATOM |
7.62x39 Portugese Brass Cased Ammo |
Lead | |
|
I was checking ammo boxes this week when I came across some of this type ammo. It came in Green battle packs marked 200 rds 7.62.39,
the headstamp is marked 7.62x39 with a 76 at the top. Primers have the green coating. I don't believe it to be Portugese and not sure if it is corrosive or not. Anybody familiar with this type of ammo? I bought it from AIM a while back. Thanks. |
|||
m1 talker |
|||
|
I have never been able to find any of it, but I have heard reports that it is good stuff. I would like to find some and give it a try out and see how it
compares to the other milsurp varieties. As for corrosiveness, I would consider it corrosive until proven otherwise. I also would suspect that it is Berdan
primed, but you would have to look at a fired round to make sure. Small gunshow here tomorrow and I will keep my eyes open, but lately ammo at the gunshows has
not been as common as it was just a few years ago.
Curt |
|||
WVchuck |
|||
|
It is berdan primed and non-corrosive and great shooting ammo.
It's comaparable to the 7.92 Portuguese ammo as far as quality control is concerned.
|
|||
ammolab |
|||
|
The Portugese did make 7.62x39mm ammo. Great stuff and NONcorrosive for sure. That ammo is not Portugese. All the Portugese I have seen in that caliber
was packed in 32rd boxes and 320rd Paks...same pack you see all the other Port. rifle ammo in. Headstamp was "FNM". I know they heastamp to
customers wishes...but the packaging always looks Portugese. This ammo and Pak look different for sure.
|
|||
WVchuck |
|||
|
The stuff I shot was used in a Yugo SKS that I let set for several days.
I checked it every day for over a week with no signs of corrosion.
|
|||
temperflash |
|||
WVchuck wrote:Well thats one way to do it. The recommended method of testing ammo to see if it has corrosive primers is to pull the bullet and dump the powder, then take a small mild steel plate (not stainless or plated in any way of course) and polish it bright with fine sand paper, being sure there is no oil on it, Set the steel plate an inch in front of the muzzle, load and fire the emptied case in the rifle so only the residue and gases of the primer contact the plate, Clean your rifle well then to be on the safe side, Set the dry and residue contaminated plate in a small closed box (shoe box is good)with a cup of warm (not hot) water. If corrosive the plate should begin to show rust at the point of contamination in 24 hours or less. If no rust shows in 24 hours let it sit a couple of days longer to be sure. |
|||
WVchuck |
|||
|
Honestly, we had just finished up a range event a few years ago when this ammo showed up, along with the "is it corrosive?" question, so rather than
clean things up right away after the shoot, I left it accessible for a week, checking the bore each morning and evening.
I've seen some really corrosive ammo start to work on a bore in less than 24 hours in the past, and I figured if nothing showed up within a day or two, it was non-corrosive, but let it go until the next weekend just to be 100% positive. It was a lot more fun to actually shoot 80+ rounds and get the full effect!
|
|||
Hessenfesser |
|||
|
All the Iranian that I've seen was dated in the mid-90's and I did clean as if it was corrosively primed after firing that ammo. Any com-bloc ammo from
the 70's is likely to be corrosive, so any 7.62x39 from that time should be considered to be corrosively primed unless it can be proven to be otherwise
(like the Portugese).
~Hessenfesser |
|||