Hello everyone, I have a problem I can't seem to correct. CZ52: When the slide is retracted the oval notch in the slide pushes the disconector/trigger
bar down as it should, problem is the trigger bar will not spring back. The trigger bar seems to be hanging up on the hammer pivot-stud. I've used some
grease on the contact areas of the trigger bar and stud and it does help.
The result is when the slide is retracted (w/o a magazine or with an empty magazine of course) the trigger must be pulled about 1/32 of an inch BEFORE it rests between the hammer stud and the sear lever. Once in this position I have the usual small amount of take-up before "feeling" the trigger bar engaging the sear lever (this small amount of take-up is of course normal)
If I drop the hammer (held back by finger pressure so not to break the firing pin) and hold the trigger back and then retract the slide (as if the pistol was being fired) I do not get the problem with the trigger bar sticking or falling down too low.
Kenny
The result is when the slide is retracted (w/o a magazine or with an empty magazine of course) the trigger must be pulled about 1/32 of an inch BEFORE it rests between the hammer stud and the sear lever. Once in this position I have the usual small amount of take-up before "feeling" the trigger bar engaging the sear lever (this small amount of take-up is of course normal)
If I drop the hammer (held back by finger pressure so not to break the firing pin) and hold the trigger back and then retract the slide (as if the pistol was being fired) I do not get the problem with the trigger bar sticking or falling down too low.
Kenny
